S E R V I C E I N S T R U C T I O N S
1-800-KEATING
MOUNTING INSTRUCTIONS FOR REPLACING
HI-LIMIT CONTROL #004341 (BACK MOUNT)
WITH #034357 (BOTTOM MOUNT)
FOR IFM & GAS FRYERS & PASTA COOKERS
1. Line up template with reset button clearance hole in bottom of control panel back. Hold in
place & mark hole centers.
2. Drill (2) Ø0.201 (#7) holes.
3. Drill (1) 0.413 hole.
4. Install new hi-limit control using (2) #8-32 x 1/4” screws (part #017744).
FRONT VIEW OF FRYER OR PASTA COOKER
WITH CONTROL PANEL REMOVED
TEMPLATE
Align the center hole of the template below with
the existing reset button hole in the control panel
back. Drill the 3 needed holes. See View A-A.
CONTROL PANEL
BACK REF.
LINE UP TEMPLATE ON EXISTING HOLE AS SHOWN.
DRILL (2) .201 #7 HOLES AND (1) .413 "Z"
0.201
DRILL (2) #7
LINE UP WITH
EXISTING HOLE
WHEN REPLACING 004341
WITH 034357
0.413 "Z" SIZE
PART
#004341
Remove wires as shown
and replace on 034357
as shown
VIEW A-A
(BOTTOM VIEW)
HI-LIMIT RESET BUTTON
If the Hi-limit has been activated, press the red button
to reset after the oil cools.
PART
#034357
The red button is located under the control panel.
PART #031112
REV 2
DATE: 12/13/06
5/98
HiLmtCntrl
|