Operation
and Installation
Manual
NAV
Models: M3-LCD and M4-LCD
AM/ FM/ WB Stereo Receiver with Disc Player
and Touch Screen Controls
Warnings
• The driver should neither watch the display nor operate
the system while driving.
•
Do not disassemble, modify the unit or attempt to repair
the product yourself. If the product needs to be repaired,
consult your dealer.
Watching the display or operating the system will distract
the driver from looking ahead of the vehicle and can cause
accidents. Always stop the vehicle in a safe location
and use the parking brake before watching the display
or operating the system. In some states and countries,
passengers are also prohibited from watching the display.
• Do not install the unit in a place exposed to direct sunlight
or excessive heat or humidity. Avoid places with too much
dust or the possibility of water splashing.
• Backing Up Your Vehicle
• Never install the product in a location where it interferes
with your field of vision.
Do not backup your vehicle while looking at the monitor.
Always look in the direction of your vehicle’s motion.
Use the monitor only as an aid in safety confirmation.
The actual distance may be different than it appears in the
monitor. The range of the image in the monitor is limited.
Always be aware that blind spots may exist and not appear
at all times on your monitor.
• This unit has a cooling fan to decrease the internal tem-
perature. Do not mount the unit in a place where the cool-
ing fan on the unit is blocked. Blocking these openings will
inhibit the cooling of the internal temperature and result in
damage to the unit.
The product is intended to assist in safe driving and
allows the driver to have a broader field of vision dur-
ing backup. You, as the driver, are solely responsible
for the safe operation of your vehicle and the safety of
your passengers and pedestrians, and abiding all state
and local traffic regulations. Do not use any features
of this system to the extent it distracts you from safe
driving. Your first priority while driving should always
be the safe operation of your vehicle. Magnadyne will
not accept any responsibility whatsoever for accidents
and/or injuries resulting from failure to observe these
precautions or safety instructions.
• Use the proper power supply. This product is designed
for operation with a negative grounded 12V DC battery
system. Never operate this product with other battery
systems, especially a 24V DC battery system. If the prod-
uct is used with the improper system it may cause a fire
or an accident.
• This product must be installed and used in accordance
with this manual. Any alterations to this product that
enables it to be used in any way other than intended
or designed could distract the driver and result in an
accident causing injury or death. Magnadyne Corporation
disclaims any and all liability that may result from failure
to install and operate in any other manner in which this
unit was intended.
Caution
Liquid Crystal Panel
• Any harsh impacts may damage the liquid crystal panel.
• FCC REGULATIONS STATE THAT ANY
UNAUTHORIZED CHANGES OR MODIFICATIONS
TO THIS EQUIPMENT MAY VOID THE USER’S
AUTHORITY TO OPERATE IT.
0
0
• Usage temperature range: 32 F to 104 F. When the
temperature is very cold or very hot, the image may not
appear clearly or may move slowly. Also, movement of the
image may seem to be out of synchronization or the image
quality may decline in such environments. Note that this is
not a malfunction or problem.
• TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE.
• Sudden changes in the temperature inside the vehicle such
as those which occur immediately after the vehicle’s air
conditioner or heater has been turned on may cause the
inside of the liquid crystal panel to cloud over due to water
vapor or it may cause condensation (droplets of water) to
form and, as a result, the panel may not work properly.
Do not use the unit while these symptoms are evident.
Instead, leave the unit standing for about an hour, and
then resume or start use.
• THIS DEVICE IS INTENDED FOR CONTINUOUS
OPERATION.
• TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK AND ANNOYING INTERFERENCE, USE
ONLY THE RECOMMENDED ACCESSORIES.
• If the screen of this unit is dirty, wipe the dirt off with a
cloth moistened with a mild cleaner. Note: Applying spray
cleaner directly to the unit may affect its mechanical parts
or cause an electrical shock. Wiping the screen with an
abrasive cloth or using a volatile liquid such as thinner or
alcohol may scratch or damage the surface of the screen.
3
Button Locations and Functions
1
2
3
4
5 6
5. Eject Button: Press to eject a disc.
6. Infrared Eye: Receives the signals from the
remote control.
7. SD Card Slot: Insert the SD card to play record-
ed music data.
Notes: This unit may not play all SD cards. The
manufacturer of this unit is not responsible for any
data loss. We suggest you back up your data.
7
8
9
10
11
8. USB Input: Plug in your USB device. “USB” will
appear in the display.
Note: This unit may not function with all MP3
players. The unit will control the USB audio
device. (See “MP3 Operation” for more details).
1. Volume Button: Push (+) to increase or (-) to
decrease the volume level.
2. Power/Navigation Button ( ): Press to turn the unit
on. Press and hold for 3 seconds to turn the unit
Off. Press and release to switch to Navigation mode,
press and release again to return to last source.
Note: Navigation only available on M4-LCD.
9. Audio/Video Input Jack: Plug in a device with a
3.5mm audio/input plug. The M4-LCD/M3-LCD
will not control the device, it just allows the
audio/video to be played through the system.
3. LCD Display: Touch to interact with the display
screen.
10. Microphone
11. Restart Button: Press the restart button if the
4. Disc Slot: To play a disc, insert a disc into the
slot with the label facing up.
unit freezes up or does not function correctly.
Remote Control Button Locations and Functions
1
1. Volume: Decrease (-) or Increase (+) the volume
level.
VOLUME
EJECT
POWER
2. Power On/Off ( ): Turn the unit On or Off.
16
17
2
3
WB
ASM
LOUD
BAND
MODE
3. Weather Band (WB): Press for direct access to
the weather band radio.
18
20
4
6
8
CAMERA SUB-W
EQ
AUDIO DISPLAY
SETUP
19
21
5
7
4. Automatic Station Memory (ASM): Press and
hold for automatic station memory storing.
Press and release for scanning memorizes sta-
tions.
HOME
TITLE
22
23
OK
9
5. Camera: Press to change the source to camera
mode.
10
24
25
27
DVD
MENU
SEL
MUTE
11
TUN-
TUN+
12
13
6. Equalizer/Sub Woofer (EQ/SUB-W): Choose
between preset sound equalization settings.
Press and hold to turn the sub woofer On and Off.
26
28
REPEAT SHUFFLE ANGLE
BACK
ZOOM
GOTO
TA
14
15
1
4
7
0
2
3
6
29
30
7. Home: Return unit back to the Homepage menu.
8. Title: Displays the title menu that is stored on
the movie disc.
5
8
9
31
32
S-MOD
IPOD MENU
9. Play/Pause (
): Starts and pauses disc play.
SUB-T
PTY
10+
33
10. Stop ( ): Stops disc play.
4
Remote Control Button Locations and Functions (Continued)
11. DVD Menu: Displays the movie menu.
19. Display: Displays source information.
�� ��
20. Audio: Changes the language on multi-language
12. Tune/Track/Chapter (l
,
l) :
movie discs.
Radio: Press and the tuner will scan to the
next strong station and stop. Press and hold
until “MANUAL” appears in the display then
release. Then press again until the desired
radio station is tuned-in.
21. Setup: Access the Movie Disc Setup Menu, a
movie disc has to be inserted.
�
�
22. Cursor: (s, , t, ): Moves feature selec-
tion up, down, left or right.
Music Disc: Press to change to a lower or
higher track.
Movie Disc: Press to change to a lower or
higher chapter.
23. OK: Confirms the selected item.
24. Select (SEL): Accesses the Sound menu.
25. Mute: Mutes the volume.
13. Repeat: Repeats play of chapters, titles, tracks
and discs.
26. Slow Motion ( ): Press to play the movie
disc in slow motion.
14. Shuffle: Plays all the tracks on the music disc
in random order.
27. Back: Selects previous screen.
28. Angle: Changes the view angle on multi-angle
15. Numeric Keypad: Inputs the corresponding
movie discs.
number.
29. Zoom: Enlarges or reduces the size of movie
16. Eject ( ): Ejects the loaded disc.
picture.
17. Mode: Switches through the available sources.
30. Goto: Used in conjunction with the numeric
18. Band/Loud:
keypad to skip to the desired chapter.
Radio: Selects AM1, AM2, FM1, FM2 and FM3
radio bands.
Loudness: Press and hold button until “LOUD
ON” appears in the display to boost high and
low tones at low volume levels. To deacti-
vate, press and hold again until “LOUD OFF”
appears in the display.
31. Traffic Announcement (TA): Activates the
traffic announcement function. (See the Radio
Operations section for more information).
32. PTY: Activates the PTY screen which scans FM
radio stations according to program type.
33 . Subtitle (SUB-T): Accesses movie disc’s sub-
title languages.
Basics Operation
Turning On/Off the Unit:
Turning On:
• If the unit was switched off by turning off the
vehicle, when the vehicle is started the unit will
automatically turn on.
•
If the unit was switched off by pressing and
holding the power button ) for 3 seconds
when the vehicle is started you must press the
power button to turn the unit on.
Turning Off:
(
,
(
)
MIC
RES
• Turning off the vehicle will automatically turn
off the unit.
• Press the power button ( ) for 3 seconds will
turn the unit off.
Note (M4-LCD Only): Pressing and releasing
the power button ( ) switches the unit to the
Navigation mode, press and release again to
return to last source.
5
|