Metra Electronics Car Stereo System 95 7867 User Manual

INSTALLATION INSTRUCTIONS FOR PART 95-7867  
APPLICATIONS  
Acura RSX  
2002-2006  
95-7867  
KIT FEATURES  
• Double DIN Radio Provision  
• Stacked ISO Mount Units Provision  
KIT COMPONENTS  
A) Double DIN Trim Plate  
A
TOOLS REQUIRED:  
• Phillips Screwdriver • Panel Removal Tool  
1-800-221-0932  
© COPYRIGHT 2007 METRA ELECTRONICS CORPORATION  
 
95-7867 DASH DISASSEMBLY  
ACURA RSX 2002-2006  
A
1
2
3
Disconnect the negative battery ter-  
minal to prevent an accidental short  
circuit.  
Unclip the power outlet panel and  
remove (2) Phillips screws exposed  
facing up. (“A” in Figure A)  
Unclip the radio trim panel assembly  
(including the head unit and the haz-  
ard switch) then unplug and remove  
the assembly. (Figure A)  
B
4
5
6
Remove (4) Phillips screws securing  
the factory head unit to the bracket  
assembly and remove the unit.  
(“B” in Figure A)  
"C"  
"C"  
"C"  
"C"  
If a factory pocket is present,  
remove (4) Phillips screws securing  
the pocket to the bracket assembly  
and remove.  
Remove (4) Phillips screws securing  
the bracket assembly to the back of  
the radio trim bezel and remove the  
bezel. (Retain the bracket assembly  
and screws to be reinstalled into the  
double DIN trim plate during kit  
assembly) (“C” in Figure B)  
C
Remove (2) Phillips screws securing  
the hazard switch to the back of the  
radio trim panel and remove the  
switch. (Retain the switch and screws  
to be reinstalled into the double DIN  
trim plate during kit assembly)  
(“D” in Figure C)  
7
"D"  
"D"  
Continue to kit assembly.  
1
 
95-7867 KIT ASSEMBLY  
DOUBLE DIN RADIO PROVISION  
STACKED ISO MOUNT UNITS PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
3
Mount the hazard switch to the back of  
the Double DIN Trim Plate using the  
factory hardware. (Removed in step 7  
of dash disassembly) (Figure A)  
Mount the bracket assembly (Removed  
in step 6 of dash disassembly) to the  
back of the Double DIN Trim Plate  
using the factory hardware. (Figure B)  
Slide the Double DIN radio or stacked  
ISO mount units into the bracket/radio  
B
housing assembly and secure to the  
assembly using the screws supplied  
with the Double DIN head radio or  
stacked ISO mount units. (Figure C)  
Continue to final assembly.  
C
2
 
95-7867 FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
3
 
95-7867  
NOTES  
4
 
95-7867  
NOTES  
5
 
95-7867 INSTRUCTIONS  
1-800-221-0932  
REV. 11/02/07 © COPYRIGHT 2007 METRA ELECTRONICS CORPORATION INST95-7867  
 

Land Pride Lawn Mower PR1672 User Manual
Land Pride Lawn Mower RCR26 Series User Manual
Liebherr Refrigerator HC 2062 User Manual
Lindy Network Card USB Bluetooth Adaptor User Manual
Linksys Network Router RV042 User Manual
Lowrance electronic GPS Receiver LMS 330C User Manual
Magnavox Stereo System MME100 User Manual
Mamiya Power Supply 6MF User Manual
Marmitek Stereo Receiver A V Equipment User Manual
Memorex Microcassette Recorder VX730 User Manual