Metra Electronics Power Screwdriver 99 7866 User Manual

INSTALLATION INSTRUCTIONS FOR PART 99-7866  
APPLICATIONS  
ACURA MDX 2001-2006  
99-7866  
KIT FEATURES  
• DIN Mount Radio Provision with Pocket  
• ISO Mount Radio Provision with Pocket  
KIT COMPONENTS  
A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Bracket Supports For Display  
B
C
A
D
TOOLS REQUIRED:  
Small Flat Blade Screwdriver/ Panel Removal Tool  
• Phillips Screwdriver • Socket Set  
1-800-221-0932  
© COPYRIGHT 2003-2008 METRA ELECTRONICS CORPORATION  
 
99-7866 DASH DISASSEMBLY  
ACURA MDX 2001-2006  
A
Disconnect the negative battery ter-  
minal to prevent an accidental short  
circuit.  
1
2
3
Unclip and remove trim panel around  
radio/display including a/c vents..  
(Figure A)  
Remove (6) mounting screws and  
remove the audio/display unit from  
the dash. (Figure B)  
4
Remove (8) screws from the audio  
unit and (6) screws from the display  
unit and remove the brackets from  
the audio/display assembly.  
Continue to kit preparation.  
B
1
 
99-7866 KIT PREPARATION  
DISPLAY UNIT ASSEMBLY  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
Using the mounting screws from the  
display unit, attach the brackets  
supplied with the kit by aligning the  
guide pins on the display with the  
holes on the bracket. (Figure A)  
1
2
Align guide pins on bottom of display  
unit with holes on top of housing and  
attach the unit to the housing using  
the (2) screws previously removed.  
(Figure B)  
Continue to kit assembly.  
B
2
 
99-7866 KIT ASSEMBLY  
DIN MOUNT RADIO PROVISION WITH POCKET  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Slide the DIN cage into the radio hous-  
ing and secure by bending the metal  
locking tabs outward. (Figure A)  
Slide the aftermarket radio into the DIN  
cage until it snaps into place. (Figure B)  
Continue to final assembly.  
B
3
 
99-7866 KIT ASSEMBLY  
ISO MOUNT RADIO PROVISION WITH POCKET  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
Mount the ISO Brackets to the radio  
using the screws supplied with the  
radio. (Figure A)  
2
3
Slide the radio into the radio opening  
until it snaps into place. (Figure B)  
Snap the ISO Trim Plate onto the front  
of the Radio Housing. (Figure B)  
Continue to final assembly.  
B
4
 
99-7866 FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifictions.  
Enjoy your newly installed radio!  
5
 
99-7866 INSTRUCTIONS  
1-800-221-0932  
REV. 12/29/08 © COPYRIGHT 2003-2008 METRA ELECTRONICS CORPORATION INST99-7866  
 

Land Pride Lawn Mower 357 131A ZT72 User Manual
Lenovo Laptop Z475 User Manual
Lincoln Convection Oven 1600 000 A User Manual
Little Wonder Blower MAN 4163480 User Manual
Lowrance electronic Fish Finder X47 User Manual
Magic Chef Microwave Oven MCM1110STK User Manual
Magnavox DVD Player MDV434 User Manual
Makita Trimmer PTR2500 User Manual
MB QUART Car Stereo System RSD 213 User Manual
MicroBoards Technology DVD Recorder CopyWriter PRO Series User Manual