GBC Laminator H425 User Manual

HeatSeal™  
H425  
G
F
D
I
O
E
P
T
K
c
Instruction Manual  
Manuel d’utilisation  
Bedienungsanleitung  
Manuale d’istruzioni  
Gebruiksaanwijzing  
Manual de instrucciones  
Manual de Instruções  
Kullanım Kılavuzu  
Οδηγίες  
Brugsvejledning  
FI  
o
Käyttöopas  
NO  
o
Bruksanvisning  
S
Q
o
Bruksanvisning  
Instrukcja obsługi  
Návod k obsluze  
Használati útmutató  
CZ  
H
RUS  
o
Руководствo по  
зкcплyатации  
 
2
3
1
5
4
 
Specifications  
GBC HeatSeal H425  
Electrical  
230V / 50Hz / 3.5A / 750W  
Machine Dimensions  
Machine Weight  
550 x 170 x 140mm  
5.5kg  
Maximum Pouch Width  
Minimum/Maximum Pouch Thickness  
Maximum Thru-put Thickness  
Warm-Up Time (2 x 75 mic)  
Speed  
320mm  
2 x 75 mic (Total 150) / 2 x 250 mic (Total 500)  
1mm  
3-5 minutes  
400mm per minute  
Safety instructions  
Important safeguards  
m
m
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT  
TO ACCO BRANDS EUROPE. IN THIS INSTRUCTION MANUAL AND ON  
THE PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE  
MESSAGES CAREFULLY.  
WARNING: FOR YOUR PROTECTION DO NOT CONNECT  
THE POUCH LAMINATOR TO ELECTRICAL POWER UNTIL  
YOU READ THESE INSTRUCTIONS COMPLETELY. KEEP  
THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR  
FUTURE REFERENCE. TO GUARD AGAINST INJURY, THE  
FOLLOWING BASIC SAFETY PRECAUTIONS MUST BE  
OBSERVED IN THE SET-UP AND USE OF THIS PRODUCT.  
m
THE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY  
MESSAGE IN THIS INSTRUCTION MANUAL.  
m
THIS SYMBOL INDICATES A POTENTIAL PERSONAL  
SAFETY HAZARD THAT COULD HURT YOU OR OTHERS,  
AS WELL AS CAUSE PRODUCT DAMAGE OR PROPERTY  
DAMAGE.  
General safeguards  
• Use the unit only for its intended purposes of laminating documents.  
THIS WARNING IS FOUND ON THE PRODUCT.  
• Do not place anything in the throat opening of the laminator other than  
pouches/documents.  
WARNING  
cm  
Electrical shock hazard.  
• Place unit on a secure, stable work area to prevent the unit from  
falling and possibly causing personal injury and damage to the unit.  
Do not open. No user  
servicable parts inside.  
Refer servicing to qualified  
service personnel.  
• Follow all warnings and instructions marked on the unit.  
• The socket outlet shall be installed near the equipment and shall be  
easily accessible.  
• Do not attempt single side lamination, this will destroy the laminator.  
• Do not block the vent slots, this will cause the laminator to overheat.  
This safety message means that you could be seriously hurt or killed if  
you open the product and expose yourself to hazardous voltage.  
Electrical safeguards  
Special notice  
• The unit must be connected to a supply voltage corresponding to the  
electrical rating shown on the unit.  
Thank you, for your recent purchase of a GBC Pouch Laminator. Your  
new laminator may emit a slight odour during the initial stage of  
operation. It is normal and will diminish after several hours of operation.  
• Unplug the unit before moving it, or when it is not in use for an  
extended period of time.  
• Do not operate with a damaged supply cord or plug. Do not alter the  
attachment plug. The plug is configured for the appropriate electrical  
supply.  
Cleaning  
Caution: Unplug this product before cleaning.  
m• Wipe exterior only with a damp cloth. Do not use detergents  
or solvents.  
• Do not overload electrical outlets beyond their capacity; fire or  
electrical shock could result.  
• The unit is intended for indoor use only.  
• Do not use aerosol dusters or cleaners  
• Do not spill liquid of any kind on this product.  
• Do not spray anything into the product, foreign substances  
can be explosive.  
• Close supervision is required when this product is used near children.  
Service  
• Do not attempt to service or repair the pouch laminator yourself.  
Unplug the unit and contact an authorised ACCO Brands Europe  
service representative for any required repairs.  
 
G
Operation, hot lamination  
Reverse feature  
1
Connect the power cord plug to the appropriate power source.  
In the event of a misfeed or a jam follow these instructions.  
2
3
1
Push the power button to “ON” position. The red power indicator will  
illuminate (fig.1).  
Press the reverse button  
the rotation of the rollers allowing the pouch to exit the front of the  
machine.  
and hold down (fig.5). This will reverse  
Using the lamination guide located on the machine (fig.1), select the  
appropriate temperature setting for the pouch gauge thickness and  
material you are laminating using the rotary knob control.  
2
3
Pull the document out of the laminator.  
After the document is out of the machine clean the rollers by  
running the cleaning sheet through the laminator.  
Temperature Setting Guidelines  
When laminating thin paper with light ink coverage, set the temperature  
dial to the low end of the film gauge range. Thick paper with heavy ink  
coverage requires higher settings within the range. Temperature settings  
will vary due to the finish, chemistry, and heat absorption properties  
of the material being laminated. If the laminated pouch is cloudy after  
the first pass through the machine, adjust the temperature to the next  
higher position and run it through again. If waviness occurs, reduce the  
temperature to the next lower position. Always allow sufficient time for  
the laminator temperature to adjust to the changes made to the settings.  
Caution: Use caution when removing the laminated pouch  
from the machine. It may be hot.  
m
Note  
1
2
3
Never insert the loose end of the pouch first into the machine. This  
could cause the machine to jam.  
4
When the laminator has reached the correct lamination temperature  
the green (ready) light will illuminate.  
Never attempt to do single sided lamination. This will cause the  
machine to jam.  
5
Centre the item to be laminated within the pouch left to right with  
the top edge against the sealed edge of the pouch (fig.2).  
After laminating run a clean card through the machine to clean glue  
residue off of the rollers. This will extend the life of the rollers.  
6
7
Insert the pouch with the sealed edge first into the machine (fig.3).  
The laminated item will automatically exit at the rear of the machine.  
After the pouch has stopped moving, carefully remove from the  
machine and place on a cool flat surface for approximately one  
minute for cooling (fig.4).  
8
If you are finished laminating push the power switch to turn the  
machine off.  
Operation, cold lamination  
1
Connect the power cord plug to the appropriate power source.  
2
Push the power button to “ON” position. The red power indicator will  
illuminate (fig.1).  
3
4
Rotate the temperature dial to  
position.  
Follow the instructions included with your GBC self adhesive  
laminate or other pressure sensitive, non thermal laminating  
pouches.  
Guarantee  
Operation of this machine is guaranteed for two years from date of  
purchase, subject to normal use. Within the guarantee period, ACCO  
Brands Europe will at its own discretion either repair or replace the  
defective machine free of charge. Defects due to misuse or use for  
inappropriate purposes are not covered under the guarantee. Proof  
of date of purchase will be required. Repairs or alterations made by  
persons not authorised by ACCO Brands Europe will invalidate the  
guarantee. It is our aim to ensure that our products perform to the  
specifications stated. This guarantee does not affect the legal rights  
which consumers have under applicable national legislation governing  
the sale of goods.  
Register this product online at www.accoeurope.com  
 
New details to  
be advised.  
Service  
G
ACCO Service Division  
Freepost 193, Hereward Rise, Halesowen, West Midlands, B62 8AN.  
N
I
Sannum & Stang  
Gladengveien 16 0661 Oslo.  
Tel: +4722685940, Fax: +4722686730, e-mail: [email protected]  
ACCO UK Sales International  
Oxford Road, Aylesbury, HP21 8SZ.  
Tel: 00 44 1296 397444, Fax: 00 44 1296 311000  
ACCO Italia Spa  
Via Nenni 13, Settimo Torinese (TO) Via Regio Parco 10B/bis.  
Tel: 011 896 11 11, Fax: 011 896 11 12  
IRE  
F
O
B
D
ACCO France  
o
ACCO-Rexel Ltd  
Clonshaugh Business & Technology Park, Clonshaugh Dublin 17.  
Tel: 01 816 4300, Fax: 01 816 4302  
Service Aprés-Vente, 8 Rue du 19 Mars 1962, 21601 Longvic, Cedex BP7/ZI.  
Tel: 0802 872 356, Fax: 03 80 68 60 49  
ACCO Benelux  
Peppelkade 64, 3992AK Houten.  
Q
S
ACCO Polska Sp. z o.o.  
Al-Jerozolimskie 184, 02-486 Warszawa.  
Tel: +42 22 570 18 01, Fax: +48 22 570 18 33  
ACCO Benelux (Technische Dienst)  
Peppelkade 64, 3992AK Houten, Nederland.  
ACCO Nordic Region  
Kontor 1, i norden AB Kanalvägen 16 194 61 Upplands Väsby.  
Tel: 08 444 5191, Fax: 08 444 5199  
FI  
o
ACCO Deutschland  
H ATernl:o+ld4s9tra-s7s1e851,/7838671-146S0c,oFranxd:o+rf4,9Ge-r7m1a8n1y./887-165  
Somen Huoltopalvelu oy  
Kanaamouka 1 00360 Helsinki. Tel: 956 050 510, Fax: 956 050 500  
RUS  
o
E
CZ  
o
A
S
XERTEC a.s.  
P AIsCaaCcOPIebrearli1a9S, L28820 Coslada (Madrid). Tel: 91 669 9391, Fax: 91 672 07 11  
U Továren 770/1b, 102 00, Praha 10.  
g
Oddi  
Höfdabakka 3-7 IS-112 Reykjavik. Tel: 00354 515 5000, Fax: 00354 515 5101  
ACCO Österreich  
Sallmann Bürotechnik GmbH, Esshaverstrasse 16, 5020 Salzburg.  
Tel: 0662 4345 160, Fax: 0662 4345 164, e-mail: [email protected]  
T
Eraysan  
Ankara Cad N.129, Sirkeci, Istanbul.  
Tel: 0090 212 6591686, Fax: 0090 212 5226992, [email protected]  
ACCO Schweiz  
AUS  
o
ACCO Australia Pty.  
Level 2 Building B, 8 Lord Street, Botany. NSW. Australia 2019.  
Tel: 2 9700 0180, Fax: 2 9700 0195  
ABC Bürotechnik AG, Winkelbüel 4, 6043 Adligenswil.  
Tel: 041 375 6060, Fax: 041 375 6061,  
c
Mailtech  
Baldersbaekvej 8B 2635 Ishoj.  
Tel: 045 43 73 37 37, Fax: 0045 43 73 73 37 07, e-mail: [email protected]  
ACCO Brands Europe  
Oxford House  
Aylesbury HP21 8SZ  
United Kingdom  
Ref: H425/5278  
Issue: 01 (03/07)  
 

Cisco Systems Network Router 6500 7600 User Manual
Clover Electronics Digital Camera CC5301 User Manual
Craftsman Lawn Mower 37061 User Manual
Craftsman Trimmer 31679192 User Manual
Creative Digital Camera 3200Z User Manual
Dymo Postal Equipment PS2R1 1P User Manual
Everpure Water System QL2 OW200L User Manual
FieldServer Computer Drive FS 8700 73 User Manual
Franke Consumer Products Ventilation Hood FKU 368 TC I User Manual
Gigabyte Portable Speaker GP S5500 User Manual